Next: Running programs backward, Previous: Running Programs Under ROCGDB, Up: Debugging with ROCGDB [Contents][Index]
The principal purposes of using a debugger are so that you can stop your program before it terminates; or so that, if your program runs into trouble, you can investigate and find out why.
Inside ROCGDB, your program may stop for any of several reasons,
such as a signal, a breakpoint, or reaching a new line after a
ROCGDB command such as step
. You may then examine and
change variables, set new breakpoints or remove old ones, and then
continue execution. Usually, the messages shown by ROCGDB provide
ample explanation of the status of your program—but you can also
explicitly request this information at any time.
info program
Display information about the status of your program: whether it is running or not, what process it is, and why it stopped.